Installation Of Handle Assembly - Holzmann TS 255 M Bedienungsanleitung

ASSEMBLY
1. Table saw
2. Out feed support
3. Miter gauge
4. Blade guard
5. Rip fence
6. Blade wrench
7. Handle assembly
8. Push stick
9. Hex wrench 4mm ,5mm
Carefully lift the saw from the carton and place it on a level work surface ．
Inspect the tool carefully to make sure no breakage or damage occurred during shipping ．
WARNING: If any parts are damaged or missing, do not operate this tool until the missing parts
are replaced ． Failure to do so could result in possible serious personal injury
．
WARNING: Do not connect to power supply until assembly is complete. Failure to comply could
result in accidental starting and possible serious personal injury ．
12.3

Installation of handle assembly

Lift the end cap off the handle assembly using a flat blade
screwdriver ．
Hold the nut securely and turn the screw counterclockwise
to remove the nut completely ．
Place the nut into the recessed hole on the back of the
height/bevel adjusting handwheel and hold in place ．
Slide the handle and screw into the hole on the
height/bevel adjusting handwheel ．
Using the hex wrench, turn the screw clockwise and tighten
in place ．
Push the end cap back in place on the end of the handle ．
HOLZMANN Maschinen Austria ξ www.holzmann-maschinen.at
Seite 28
Bedienungsanleitung Universalfräsmaschine BF 500 mobile Tischkreissäge / mobile circular saw TS 255M