Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The machine does not require extensive maintenance.
Repairing shall be performed by trained professionals only.
Accesories: Use only accesories recommended by HOLZMANN-Maschinen and its sales
partners.
12.3
Remaining risk factors
Even if the machine is used as required it is still impossible to eliminate certain residual risk
factors totally. The following hazards may arise in connection with the machine´s construction
and design:
Damage to hearing, when sound levels in workshop add up to a total level being harmful.
Wear ear-muffs to eliminate this risk factor.
Respiratory damages due to harmful emissions of wood dust.
Severe cutting injuries at contact with the running band in the uncovered cutting zone.
Injuries (cuts) when changing the band. Wear safety gloves when changing the saw band.
Injury from catapulted workpieces or parts of workpieces.
Injury through breaking saw band
Electrocution through contact with internal leading machine parts
This risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge
and experience.
HOLZMANN MASCHINEN GmbH
Never leave the machine running unattended! Before leaving
the working area switch the machine off and wait until the
saw band stops.
Always disconnect the machine prior to any actions
performed at the machine.
Avoid unintentional starting
Each
time
you
apparatus, caution is advised! There is a risk of electric shock,
fire, cutting injury;
Protect the machine from dampness (causing a short circuit)
Use power tools and machines never in the vicinity of flammable
liquids and gases (danger of explosion)
Check the cable regularly for damage
Protect the cable from heat, oil and sharp edges
Avoid body contact with earthed
Use appropriate holding device when sawing logs
The upper blade guide to keep as close to the workpiece
Attach the fence to the lower half of the table for inclined table
Workpieces while working safely hold and guide
Remove the sawed-off or jammed workpieces only at standstill of
the saw blade
Make sure that no excessive concentration of dust is produced.
Use suitable dust extraction equipment!
Remove before editing foreign matter (nails, screws) from the
workpiece
For straight cuts against the rip fence push stick should be used
www.holzmann-maschinen.at
HOLZBANDSÄGE / MWOOD BAND SAW / SIERRA DE CINTA / SCIE À RUBAN
work
with
an
electrically
SAFETY
operated
sawing
Seite 33
HBS 700 – HBS 800
Werbung
