Thermometer; Adjustment Range Limitation; Operating Conditions - Austria Email EKH-S Bedienungs- Und Montageanleitung

EKH-S, EWH, ES

THERMOMETER

There is a remote thermometer built into the front panel of the device
for monitoring the stored water temperature.
The display value depends upon the temperature regulator setting. Only
with the adjustment knob at „Pos." and after completion of the warm
up process is the maximum display value reached.
For other regulator positions the pointer deflection is reduced accor-
dingly.

ADJUSTMENT RANGE LIMITATION

In order to avoid unintentional scalding caused by water which is
too hot, the adjustment range of the temperature regulator can
be limited to a maximum of 65°C. The device must be electrically
isolated from the grid at all poles. Set to „Pos ". After opening
the connection space, remove the stop pin in that is located in
a drilling in the back of the control panel and reinsert it into the
hole with the long shaft in front.

OPERATING CONDITIONS

The tank must be used exclusively in accordance with the conditions specified on the rating plate. The maximum
inlet pressure corresponds with the nominal pressure stated on the rating plate. Aside from the legally approved
national regulations and standards, the connecting requirements of the local power company and waterworks, as
well as the Mounting and Operating Instructions must be complied with. The room in which the device is opera-
ted must be free of frost.
The device must be mounted at a location that may reasonably be expected, i.e. it must be possible to access and
replace the device without difficulties for the purpose of necessary maintenance, repairs and possible replace-
ment. The hot water tank must only be connected with permanent piping. In the case of heavily calciferous water,
we recommend the upstream integration of a customary anti-liming device or a maximum operating tempera-
ture of approx. 65 °C (position ).
An appropriate quality (according to drinking water ordinance) of drinking water is required for proper operation.
To avoid possible ingresses of particles, we recommend the upstream integration of a water filter.
Should a device, at the point of delivery, clearly display a malfunction, damage or other defect, this must not be
fitted, installed or used in the system. Subsequent complaints regarding devices with an obvious defect which
have been connected and installed are expressly excluded under the warranty and guarantee.
24
Id. Nr.: 246588-12
Remote reading thermometer