Controls And Features - Holzmann DF 1200N Originalbetriebsanleitung

CONTROLS AND FEATURES

6 CONTROLS AND FEATURES
1. Headstock Lock Handle: (D, Fig.4) Locks head in position. Unlock handle to position the head
along lathe bed. Tighten handle when properly positioned.
2.. Headstock On/Off Button: (F, Fig.4) Pull the button out to turn "ON" the lathe. Push the but-
ton in to turn the lathe "OFF".
3. Headstock RPM Knob: (G, Fig. 4) Turn knob to desired RPM. There are two speed ranges offer-
ing "speed" (330-3200) and "torque" (100-1200).
4. Headstock For/Rev Switch: (H, Fig. 4) Use the toggle switch to change the direction the spindle
turns. Only change direction when the spindle has stopped.
5. Headstock RPM Readout: (I, Fig. 4) Displays the spindles RPM, see Figure 5.
6. Headstock Spur Center: (J, Fig. 6) Used for turning between centers. Spindle taper is MT-2.
Remove spur center by inserting drift rod through the opposite end of the spindle and knocking
spur center out.
Fig. 5 Fig. 6
7. Headstock Faceplate: (K, Fig. 6) Used for turning bowls and plates. There are a number of
screw holes for mounting the workpiece. Thread the faceplate onto the spindle in a clockwise di-
rection, and tighten two set screws. Remove the faceplate by loosening two set screws. Push in
headstock spindle lock and use the provided rod in faceplate holes to unthread the faceplate.
8. Headstock Indexing Hole: (L, Fig. 6) Thread indexing pin into the indexing hole making sure
that it locates in the spindle hole. There are 12 holes in the spindle 30° apart. There are three
holes in the headstock casting that accept the indexing pin. These holes are 20° apart. The com-
bination of holes will allow you to mark your workpiece for evenly spaced features.
CAUTION! Never start the lathe with the index pin engaged in the spindle!
9. Tool Rest Body Lock Handle: (M, Fig. 7) Locks the tool rest body in position. Unlock handle to
position the tool rest in any location along lathe bed. Tighten handle when properly positioned.
10. Tool Rest Lock Handle: (N, Fig. 7 Locks the tool rest in position. Unlock the handle to position
tool rest at a specific angle, or height. Tighten handle when properly positioned.
11. Tailstock Lock Handle: (O, Fig. 8) Locks the tailstock in position. Unlock handle to position the
tool rest in any location along lathe bed. Tighten handle when properly positioned.
12. Tailstock Quill Lock Handle: (P, Fig. 8) Locks the tailstock quill in position. Unlock handle to
position the quill. Tighten handle when properly positioned.
13. Tailstock Quill Handwheel: (Q, Fig. 8) Turn the handwheel to position the quill. The tailstock
quill lock handle must be loose to position quill.
14. Tailstock Live Center: (R, Fig. 8) Used for turning between centers. Quill taper is MT-2. Re-
move live center by retracting the quill until live center loosens. Remove, or add different tips to
the live center by inserting the provided rod through
HOLZMANN Maschinen Austria  www.holzmann-maschinen.at Seite 27
Bedienungsanleitung DF 1200N