Herunterladen Inhalt Inhalt Diese Seite drucken

Getting Started With The Transmitter; A) Screwing The Antenna Of The Transmitter; B) Inserting The Batteries/Rechargeable Batteries; C) Loading The Rechargeable Batteries For Transmitter - Reely 20 55 11 Bedienungsanleitung

Ep flugmodell rtf
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen



9. Getting started with the transmitter

In the operating instructions, the numbers in the text always refer to the figure opposite or the figures
within the section. Cross references to other figures are indicated with the respective figure number.
a) Screwing on the antenna of the transmitter
If necessary, the antenna of the transmitter is inserted as far as possible from the front/top though the circular opening
into the casing of the transmitter (see also figure 02, pos. 1) and is then turned like a screw. Seize the antenna as much
as this is possible manually. Use neither force nor tools to tighten it.

b) Inserting the Batteries/Rechargeable Batteries

For the power supply of the transmitter you will need 8 alkaline batteries (e.g. Conrad Item No. 652507, pack of 4,
order 2) or rechargeable batteries mignon size (AA). For ecological and also for economical reasons it is recommended
to use rechargeable batteries, since they can be recharged.
To insert the batteries or rechargeable batteries, proceed as follows:
The battery compartment lid (1) is located on the rear side
of the transmitter. Please press the corrugated triangle
and push off the lid downward.
Now insert the 8 batteries or rechargeable batteries into
the battery compartment. Observe the correct polarity of
the individual cells. A corresponding note (3) is located on
the bottom of the battery compartment.
Afterwards slide the lid of the battery compartment back
on from the bottom and let the locking mechanism click
into place.
c) Loading the rechargeable batteries for the transmitter
If you use 8 mignon accumulators for your transmitter, take these out of the transmitter for charging and recharge them
in a suitable round cell charger.
Observe the instructions of the charger's manufacturer as well as the technical data sheets of the used accumulators.
Never try to recharge common, non-rechargeable batteries (1.5V/cells) with a charger. There is
a risk of fire and explosion!
44
Figure 4

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Piper j-3

Inhaltsverzeichnis