Herunterladen Inhalt Inhalt Diese Seite drucken

During Operation - Reely 20 55 11 Bedienungsanleitung

Ep flugmodell rtf
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Check the function safety of your model and of the remote control system. Pay attention to visible damages such as
broken plug-in connections or damaged cables. All movable parts on the model have to be smooth running; however,
there must be no tolerance in the bearing.
• Charge the flight battery, which is necessary for operation, as well as the rechargeable battery needed in the remote
control according the instructions indicated by the manufacturer.
• As power source for the plug-in mains unit, use a 230V/50 Hz mains socket of the public mains only. Never try to
operate the device at another voltage.
• If batteries are used for the power supply of the transmitter, make sure that there is a sufficient rest capacity (battery
checker). If the batteries are empty, always replace the complete set, never individual cells only.
• Before each operation, control the settings of the trim slider at the transmitter for different steering directions and, if
necessary, set them.
• To operate your model, always pull out the telescopic antenna to its full length as otherwise the transmitters presents
a considerable lower range and the transmitter output is strained higher than average.
• Always switch the transmitter on first. It is only afterwards that you may connect the flight battery of the model or
switch the model on. Otherwise unexpected reactions of the electric model airplane may occur and the propeller can
start to turn unintentionally!
• Check the correct and secure position of the propeller before each operation.
• Make sure that neither objects nor body parts are in the rotating and suction area of the propeller while it is rotating.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely down to
you being responsible when dealing with the model.
• Improper operation can cause serious damage to people and property! Therefore, during operation, ensure a sufficient
safety distance to persons, animals and objects.
• Select an appropriate site for the operation of your model airplane.
• Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medicine can
cause incorrect responses.
• Do not direct your model towards spectators or towards you.
• Never point the telescope antenna of the transmitter directly onto the model. This makes the signal transmission to
the model a lot worse.
• Motor, flight control system and flight battery can heat during operation of the model. Therefore, take a break of 5-10
minutes before re-charging the flight battery or before re-starting with a possibly existing spare flight battery. The
drive engine must cool down to ambient temperature.
• Always leave the remote control (transmitter) turned on, as long as the model is in operation. After landing, always
disconnect the flight battery first or switch the model off. It is only afterwards that the remote control may be turned
off.
• In case of a fault or a malfunction, correct the fault first then re-start the model.
• Don't expose your model and the remote control for a longer period of time to direct sunlight or excessive heat.
41

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Piper j-3

Inhaltsverzeichnis