Connecting Diagram - Truma Mover XT Einbauanleitung

Mover XT XT2
Fig� 40
Secure the cables to the chassis or underbody using
the clips and screws provided�
Connect the cables before the control unit is scre-
wed in place�
Place the control unit in the stowage box and secure
with the chipboard screws provided (5 x 25 mm)�

6.2.1 Connecting diagram

The control unit (as shown in the connecting diagram)
must be connected in the following order: nut, cable
with ring eyelet, nut (torque M6 = 6 Nm; M5 = 3�5 Nm)�
PIN Description (Fig� 42)
Battery (C)
Battery + Battery + terminal, red 16 mm2
Battery - Battery - terminal, black 16 mm2
Drive assemblies in front of the axle
Motor left + Motor left + terminal, red 10 mm2
(B)
Motor left - (B) Motor left - terminal, black 10 mm2
Motor right + Motor right + terminal, red 10 mm2
(A)
Motor right Motor right - terminal, black 10 mm2
- (A)
Drive assemblies behind the axle
Motor left + Motor left + terminal, red 10 mm2
(A)
Motor left - (A) Motor left - terminal, black 10 mm2
Motor right + Motor right + terminal, red 10 mm2
(B)
Motor right Motor right - terminal, black 10 mm2
- (B)
Connector block (D)
K1-1 Safety socket, black
K1-2 Safety socket, black/red
K1-3 Data cable motor left, black 0�5 mm2
K1-4 Data cable motor left, black/red
0�5 mm2
K1-5 Data cable motor right, black
0�5 mm2
60020-00209 ∙ 00 ∙ 08/2022
K1-6 Data cable motor right, black/red
0�5 mm2
K1-7 n� c�
K1-8 n� c�
K1-9 n� c�
K1-10 n� c�
Diagnostic interface (E)
J 1 Diagnostic interface
Installation in front of the axle
(Top view)
B
Fig� 41
E
1
B A
+ - -
+
-
C
Fig� 42
M6
M5
Installation behind axle
(Top view)
A
Fig� 43
Installation
A
D
3 5 7 9
+
6 Nm
3,5 Nm
B
EN 33