9. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent. If you use multi-
tablets, activate the option Multitab.
5. Set and start the correct programme
for the type of load and the degree
of soil.
9.1 Using the detergent
D
A
30
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent in the compartment (D).
4. Close the lid. Make sure that the
release button locks into position.
A B
30
20
C
B
D
20
9.2 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
• After 5 minutes if the programme has
Starting a programme
1. Press the on/off button to activate
2. Close the appliance door.
3. Press Program again and again until
The display shows the programme
duration.
4. Set the applicable options.
5. Press Start to start the programme.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until the
C
The indicator of the selected programme
flashes.
3. Press Start.
4. Close the appliance door to start the
When the countdown is completed, the
programme starts and the washing phase
indicator comes on.
programme.
not started.
the appliance. Make sure that the
appliance is in programme selection
mode.
the indicator of the programme you
want to select comes on.
• The washing phase indicator
comes on .
• The programme duration starts to
decrease with steps of 1 minute.
display shows the delay time you
want to set (from 1 to 24 hours).
countdown.
ENGLISH
13