How To Activate The Rinse Aid Dispenser; Acoustic Signals - AEG FAVORIT55500WO Benutzerhandbuch

10 www.aeg.com
• The display shows the current
setting: e.g.
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
Use of rinse aid and multi-
tablets together
When you activate the option Multitab,
the rinse aid dispenser no longer
releases rinse aid. However if you are
using multi-tablets and the drying results
are not satisfactory, we suggest to use
multi-tablets and rinse aid together. In
this case you have to activate the rinse
aid dispenser.
The rinse aid dispenser will remain
activated until you modify the setting
again
How to activate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
and the display is blank.
2. Press Option.
• The indicators
go off.
• The indicator
continues to flash.
• The display shows the current
setting.
= level 5.
,
and start to flash
and
– = rinse aid dispenser
deactivated.
– = rinse aid dispenser
activated.
3. Press Option to change the setting.
4. Press the on/off button to confirm
the setting.
5. Adjust the dosage of rinse aid.
6. Fill the rinse aid dispenser.

6.4 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
hold simultaneously Delay and Start
until the indicators
and
and the display is blank.
2. Press Delay
• The indicators
go off.
• The indicator
flash.
• The display shows the current
setting:
– = Acoustic signal off.
– = Acoustic signal on.
3. Press Delay to change the setting.
4. Press the on/off button to confirm
the setting.
,
start to flash
and
continues to