Reely Lightning Bedienungsanleitung Seite 48

10. Adjusting the shock absorbers
The spring-pre-tension at the upper end of the shock absorber can be adjusted by inserting plastics clips (A).
The shock absorbers can be set to different positions on the front and rear axle at the lower transverse link (B). Due
to the different geometry between the chassis and the axles, there is a difference in spring behaviour. This has only a
very limited effect on the vehicle. We recommend that you do not change the existing assembly position of the shock
absorbers.
If you still want to make a change, make sure that the setting on the left and right wheel of an axle is always
the same.
48
Front axle Rear axle