Unit Switching °C And °F Or % Rh, Td Or G/M³ [Unit]; Probe Selection Prob - WIKA CTH6300 Betriebsanleitung

6. Commissioning, operation
6.4.1 Unit switching °C and °F or % r. h., td or g/m³ [Unit]
Unit = Einheit
Measuring unit temperature (°C = Celsius, °F = Fahrenheit)
GB
Measuring unit humidity (% rH = relative humidity, td = dew point, g/m³ = absolute
humidity)
Press the ENTER/MENU key and select Unit using the arrow keys ▲▼. Then press
ENTER/MENU again. A small 1 appears on the left side of the display, it indicates the
channel.
Use the arrow keys ▲▼ to select the channel for which the displayed unit needs to be
changed. Confirm by pressing ENTER/MENU.
Depending on the set probe °C/°F or % rH/td/gm³ is displayed on the right side of the
display (see chapter 6.4.2 "Probe selection Prob"). Select the required unit using the
arrow keys ▲▼ and confirm it by pressing ENTER/MENU.
Press ESC to return to the measuring mode.

6.4.2 Probe selection Prob

Press the ENTER/MENU key and select Prob using the arrow keys ▲▼. Then press
ENTER/MENU again.
A small 1 appears on the left side of the display, it indicates the channel. Using the arrow
keys ▲▼ switch the channel for which a probe should be selected.
Confirm selection by pressing ENTER/MENU. Now select the following probes using
the arrow keys ▲▼ (see table on the next page):
22
Unit Prob Lin2
Unit Prob Lin2
WIKA operating instructions, models CTH6300 and CTH6500
MENU
CAL Chnl ArEA
MENU
CAL Chnl ArEA
Lo6
Lo6