Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
N Adhesive fleece (always use with the hand
guard attached.)
O Steel wire brushes (always use with the hand
guard attached.)
P Adjusting nut (10)
Q "Quick" clamping nut
For complete range of accessories, see
www.metabo.com or refer to the main catalogue.
12. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault to the
power tool.
13. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo packaging is 100% recycled. Scrap power
tools and accessories contain large amounts of
valuable resources and plastics that can be
recycled.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately and
handed in for environmentally compatible recycling.
These instructions are printed on chlorine-free
bleached paper.
14. Technical Specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
D
= Maximum sanding disc diameter
max
t
= max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (10)
t
= max. permitted thickness of clamping
max,2
shank on accessory when using
"Quick"clamping nut
t
= Roughing disc/Parting disc:
max,3
max. permitted thickness of accessory
M
= Spindle thread
l
= Length of the grinding spindle
n
= No-load speed (maximum speed)
P
= Nominal power input
1
P
= Power output
2
m
= Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
Alternating current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission value
h, SG
(surface grinding)
a
= Vibration emission value
h, DS
(disc sanding)
K
= Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels:
L
= Sound pressure level
pA
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
ENGLISH en
17
Werbung
Inhaltsverzeichnis
