Bresser Biolux NV Bedienungsanleitung Seite 23

ually, remove the check mark from "Auto Expo-
sure" and operate the slider at "Exposure Time".
NOTE:
For an optimal result, settings
can also be made in the "Color
Balance" menu. Depending on
the camera model, individual
controls may be inactive if the
camera does not support these
functions.
TIP:
i
To work permanently with the
micro eyepiece, it is recom-
mended to always operate the
micro eyepiece on one and the
same USB port.
10. Care and maintenance
Disconnect the device from the power
source before cleaning (remove batteries)!
Clean the device only externally with a dry cloth.
NOTE:
Do not use cleaning fluid to
avoid damage to the electro-
nics.
Only clean the lenses (eyepieces and/or objectives)
with a soft and lint-free cloth (e.g. microfiber).
NOTE:
Do not press the cloth too hard
to avoid scratching the lenses.
To remove heavier dirt residues, moisten the
cleaning cloth with an eyeglass cleaning liquid
and wipe the lenses with it using little pressure.
Protect the device from dust and moisture! Allow
it to acclimatize at room temperature for some
time after use - especially in the case of high
humidity - so that the residual moisture can be
reduced.
11. Troubleshooting
Error Solution
No image • Switch on light
recognizable • Check that the selected
(when obser- objective is engaged in
ved by eye) its end position on the
revolving nosepiece
• Readjust the image
sharpness
• Check if the specimen is
placed in the center of
the image field
• Check the brightness
setting
• Check whether the
illumination setting on
the incident/transmitted
light selector switch has
been selected approp-
riately
Image is • Check whether the color
shaded side- filter disk is locked in the
ways desired end position
No live • Under menu item
image reco- "Camera list" click with
gnizable in the left mouse button on
the camera the name of the camera
software on MikrOkularHD
the PC
www.bresser.de · Biolux NV
DE
EN
23