Arzum FUENTE Gebrauchsanweisung Seite 15

EN
• Keep your appliance away from and out of reach of the children.
• Plug your device to a grounded socket without fail. To prevent harming
your appliance do not use extension cords. When using extension cords,
make sure to use grounded socket, with the cable cross section of 1mm².
• Do not place the Arzum Fuente Kettle over or near direct heat sources
such as hot gas, electric burner, or heating oven.
• Ensure that the water heater is placed on a firm and flat surface. Do
not put it on the edge of a table or bench. The least blow or knock may
overturn it. Do not forget that it may be full of hot water.
• Do not let cord hang over edge of table counter or touch any other
appliances.
• Avoid actions that may harm or damage the cord or plug of your device.
Do not carry your appliance by holding from the cord. To unplug the heater,
hold the plug and NEVER pull by the cord.
• Never interfere with your appliance except for the purposes of cleaning
and maintenance. Do not operate any appliance with a damaged cord
or plug or after the appliance malfunctions or has been damaged in any
manner, such as by dropping down, etc. Do not attempt to repair it by
yourself. Call immediately a Arzum Authorized Service.
• Always hold your appliance by its handle. Its
outer surface may be hot.
• Unplug from outlet when not in use and before
cleaning. Allow it to cool down before cleaning
the appliance.
- Use your Arzum Fuente Kettle with its own
power base unit only. Do not place it on those
belonging to any other appliance.
- The kettle will switch off automatically when
the water reaches boiling. However, if you want
to switch off before boiling you can do this
manually turning the ON/OFF switch to the
position "0".
• If you wish to re-boil the water, allow it to cool
down for about 15-20 seconds before starting
your appliance.
• If the kettle ever runs dry while operating, a
safety cut-off device will automatically cut the
ARZUM 15