13.3 Unpacking
To unpack the device, proceed as follows:
Remove the device out of the carton and remove the packaging material.
Clean the interior surface with lukewarm water using a soft cloth.
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.
13.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled. Returning the packaging back to the material loop saves
raw materials and reduces the quantities of accumulated waste. Take any packaging
materials that are no longer required to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
13.5 Setup
13.5.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must fulfil the
following prerequisites:
appliance when it is fully loaded.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption.
Ambient temperature below 10°C or above 32°C will hinder the performance of the appliance.
This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
The device requires an adequate flow of air in order to operate correctly. Leave a clearance of 8
cm around the appliance.
Do not cover up any openings on the device and do not block these off.
The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency.
The installation and assembly of this device in non-stationary setup locations must be carried out
by specialist companies / electricians, provided they guarantee the prerequisites for the safe use
of this device.
Please note
Please note
Place your appliance on a floor that is strong enough to support the
26