MSW Motor Technics MSW-BS950S Bedienungsanleitung Seite 42

3.3.5. Adjusting the Work Table Tilting
After loosening both locking screws, the work table tilts steplessly through 45° to the blade.
3.3.6. Work Table Alignment
Saw Table Lateral Alignment
1. Loosen the three fastening screws that hold the lower table trunnion.
2. Align working table so that the blade runs through the centre of the table insert's slot.
3. Tighten the three fastening screws again.
A – Locking Screw
B – Work Table
C – Pointer
D –Limit Stop Screw
E – Angle Scale