Zodiac DF2 Montage- Und Gebrauchsanleitung Seite 13

• Install the appliance in a technical room that is protected from freezing.
• At least two people are required for moving the appliance.
• Use straps (not supplied) when lifting the appliance so as not to damage it when positioning it.
2.3.2 Appliance's installation to a wall
This procedure must be only carried out by a qualified technician. Zodiac Pool Care Europe
will not be responsible for any damage or ingury incurred if this point is not observed. The
product warrantee may become void in case of failure to respect the installation procedure and
conditions of us (as specified in our general sales terms and conditions.
Required parts for sealing the DF insert
Case 1 - wall thickness = 250 mm
*minimum distance
1: DF2 models 03-05-08-10-12
through the wall
2: support seat
3: suction grid
4: blowing grids
5: Hygro Control
6: air renewal system (see §"2.1 I
Installation requirements")
7: fresh air intake
Fixing the appliance to the wall is
recommended. You have squares
(see part §"1.1 I Description").
: 1 technical room inside fram for sealing.
: 1 pools room inside frame for sealing.
: 1 pool room inside grid fixing frame
: 1 blowing grid 625 mm x 225 mm
: 1 suction grid 625 mm x 425 mm
: 6 screws
EN
13