Troubleshooting Guide - Pevino PNG20D-HHB Bedienungsanleitung

Common problems may easily be solved, saving you the cost of a possible service call. Please read carefully
the instruction manual and revert to troubleshooting guide chart.
PROBLEM
Wine cooler does not
operate.
Wine cooler is not
cold enough.
Turns on and off
frequently.
The light does not
work.
Vibrations.
The wine cooler
seems to make too
much noise.
The door will not
close properly.
TROUBLE SHOOTING GUIDE
Not plugged in.
The appliance is turned off.
Current circuit breaker (RCD) activated, or the fuse is broken.
Check the temperature control setting.
External environment may require a higher setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Room temperature is warmer than normal.
Door is opened too often.
Door is not closed completely.
Temperature control is not set correctly.
Door gasket does not seal properly.
Not plugged in.
Current circuit breaker (RCD) activated, or the fuse is broken.
Bulb is out of order.
The light button is "OFF".
Check to assure that the wine cooler is level.
The rattling noise may come from the flow of the refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant
in the wine cooler.
Contraction and expansion of the refrigerant gas may cause popping and crackling
noises.
The wine cooler is not level.
The wine cooler is not level.
The door was reversed and not properly installed.
Gasket is faulty. (Magnet or rubber is damaged)
Shelves are out of position.
POSSIBLE CAUSE
15