Operating The Hob; Residual Heat Indicator - Inventum IKI6035MAT Gebrauchsanleitung

5

operating the hob

Only use pans that are suitable for an induction hob.
After connecting the induction hob to the electrical system, it is possible that the entire display lights up for a short moment.
When this is over, the induction hob is standby and ready for use.
The induction hob works by means of electronic sensors that are operated by touching the corresponding touch controls
or sliders. At each touch of a touch control, you can hear a sound signal. Control the power by gently moving your finger
over the slider.
SWITCHING ON THE INDUCTION HOB
Switch on the induction hob by pressing the ON/OFF key for a few seconds. The displays of all cooking zones show _ .
If no cooking zone is selected within 30 seconds, the induction hob switches off automatically.
SWITCHING OFF THE INDUCTION HOB
Switch off the induction hob at any time by pressing the ON/OFF key for a few seconds.
The ON/OFF key always has priority in the switching off function.
SWITCHING ON A COOKING ZONE
Place a pan on the cooking zone. Select the required power using the slider control
to use. Control the power by gently moving your finger over the slider. Slide to the right to increase the power and to the left
to decrease the power and/or switch the cooking zone off.
To bring food to the boil quickly, touch the B at the end of the slider control to activate the Boost mode.
BOOST MODE - B
The Boost mode provides extra power and can be set for all zones, except when the bridge mode is being used.
Slide the slider control of the selected cooking zone to the highest power or directly press the B at the end of the slider
control. The Boost mode is activated when a b appears on the display of the cooking zone concerned.
When an additional cooking zone is activated, the maximum available power is exceeded and the Boost mode is stopped
automatically.
It is possible that the maximum available power for the active cooking zones together is exceeded. In that case, the power
of the cooking zones is reduced automatically. The required power reduction is shown through flashing of the cooking zone
concerned. The display flashes for 3 seconds and during that time adjustments can be made before the power is reduced
automatically.
The time period of the Boost mode is 5 minutes maximum. After 5 minutes the power returns to the previously set position
or, if no position was selected, the Boost mode returns to position 9.
SWITCHING OFF A COOKING ZONE
Select the cooking zone you wish to switch off by turning off the accompanying slider control [0].
Move a finger to the left on the slider control or directly press the outer left side of the slider control to switch off
the cooking zone.
If the cooking zone is hot, the display shows a [H] instead of an [0].
SWITCHING OFF ALL COOKING ZONES AT THE SAME TIME
To switch off all cooking zones at the same time, you must press the ON/OFF key. On the displays of all cooking zones
that are still hot, you can see an [H].

RESIDUAL HEAT INDICATOR

The residual heat indicator shows that the glass is still too hot to touch in the area of the cooking zone.
If the area of the cooking zone is still too hot, a [H] appears on the display of the cooking zone concerned.
Once the temperature has dropped, the [H] indication disappears.
PAUSE MODE
When the pause mode is activated, the power of all cooking zones being used is reduced. When the pause mode
is deactivated, all cooking zones switch back to the previously selected power.
• If the pause mode is not deactivated, the induction hob switches off after 30 minutes.
• Press the key to activate the pause mode. The power of the switched on cooking zones is reduced and [II] appears
on the displays.
• Press the pause key
at the originally selected power again.
30
• English
once more to deactivate the pause mode. [II] disappears and the cooking zones function
of the cooking zone you wish