Prior To First Use; Installation Instruction - Inventum IKI6035MAT Gebrauchsanleitung

3

prior to first use

Before using the appliance for the first time, proceed as follows: carefully unpack the induction hob and remove
all packaging material. Keep the packaging (plastic bags and cardboard) out of the reach of children. After unpacking
the appliance, check it for external damage that may have occurred during transport. Clean the glass plate with a slightly
damp cloth. Check that the voltage corresponds with what is stated on the information plate. For installing the induction
hob, observe the instructions in the following section.
4

installation instruction

• Safety during use is only guaranteed if the assembly has taken place in a technically correct way and in accordance with
these installation instructions. The installer is liable for damage caused by incorrect assembly.
• The electrical connection may be carried out only by a qualified electrician. This person should be aware of the national
and regional safety instructions with which the connection has to comply.
• The hob falls under protective class I and may only be used in combination with an earthed connection. The manufacturer
is not liable for unsuitable operation and possible damage caused by unsuitable electric installations.
• The hob must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• Induction hobs may only be installed above a drawer, an oven with forced ventilation or dishwasher, and always with
a minimum distance for ventilation. Under the induction hob, no refrigerators, ovens without ventilation or washing
machines should be installed.
• Make sure that the power supply cable does not get jammed during installation or is running along sharp edges.
If an oven is installed below it, make sure the cable runs via the rear corners of the oven to the connection box.
It must be placed in such a way that no contact is made with hot parts of the hob or oven.
• The connection point, socket and/or plug must always be accessible.
• The worktop on which the hob is placed must be flat, horizontal and stable. Observe the instructions from
the manufacturer of the worktop.
• In case of incorrect installation or connection, the warranty becomes invalid.
• Attention: any change to the appliance, including replacement of the power supply cable, must be performed
by a certified installer.
SPACE AROUND THE HOB
Safe use requires sufficient space around the induction hob. Check that this space is available.
25
English •