Maintenance And Care; Starting Operation; Filling The Metering Stations; Switching On The Equipment - Kärcher WATERCLEAN 600 HP Betriebsanleitung

Maintenance and Care

3 Maintenance and Care
The equipment may be put into operation only when set-up, installed and prepared for oper-
ation by an authorized KÄRCHER specialist dealer.
3.1

Starting Operation

Before starting operation:
• Make sure that the equipment is connected to
the untreated water source and the respective
transporting gear, e. g., admission-pressure
unit.
• Ensure the unrestricted flow of the drinking water
into a tank or a suitable device on the user side.
The drinking water must be able to run
off without counterpressure. The height
difference must not exceed 3 m.
3.1.1

Filling the Metering Stations

If the system is equipped with one or
i
more metering stations, it must be en-
sured that these are correctly filled and
connected.
• Put on protective clothing.
• Open the lid (27) of the metering station (30).
28
27
• Fill the respective chemical into the metering
station according to Section 3.2.6.
The metering stations must not be
mixed up or mistaken, meaning filled
with the wrong chemical.
4
Version 06/05
• Add the corresponding amount of chlorine-free
drinking water.
• Shut the lid of the metering station.
• Pull the mixing rod (28) out of the metering
station to the stop and push back in again.
Repeat this procedure for approx. 5 minutes
until the chemical is completely mixed.
3.1.2
• Check if the pumps of the metering station,
sand and activated carbon filter are connected
to the respective power outlets (18 / 19) at the
switch box (8).
• Check if the operating mode switch (9) is in the
correct position "Automatic" or "Hand".
i
29
• Switch the main switch (20) to the "I" position;
the system starts the drinking water produc-
tion.
3.1.3
30
Display of the controls (3 / 4) of the sand and acti-
vated carbon filters:
• Display of the time
• LED line: Display of the weekday.
Control of the RO system:
The conductivity of the drinking water is indicated
permanently in the LED display.
If the metering container was com-
pletely empty, the metering pump (29)
may have possibly drawn in air. In this
case, bleed the air from the pump as
described in Section 3.2.3.

Switching On the Equipment

In the "Automatic" operating mode, the
system is controlled via an external float
switch in the drinking water tank.
In the "Hand" operating mode, the sys-
tem is switched on and off manually via
the main switch.

Operating Indicators

WTC 600 HP