WAGNER PLAST COAT HP 30 Originalbetriebsanleitung Seite 33

Plast Coat HP 30
• Remove the sealing cap on the hose connection.
• Connect the machine to the mains supply.
The operation light (fig. 5, 1) shows operational readiness.
• Set the pressure regulator (3) to the yellow area (stage 1-4).
• Set selector switch (2) to "F".
Important: do not allow the machine to run
dry. When pumping out the conservation
agent, the stator must remain covered with
liquid (see illustration).
• Important: do not allow the machine to run dry. When
pumping out the conservation agent, the stator must re-
main covered with liquid (see illustration).
• Set selector switch (2) to "0".
• Pour coating material into the container.
When attaching the high-pressure hose to the
hose connection, hold the hose connection
with the double open ended spanner inclu-
ded in the scope of delivery.
Only use a hose that is suitable for the materi-
al in question (DN 19 for fillers and DN 10 for
dispersion paints).
• Screw the high-pressure hose (Fig. 6, 1) onto the hose con-
nection (2).
• Screw the hose whip onto the other end of the high-pressu-
re hose.
• Screw the gun onto the hose whip.
• Tighten all union nuts on the high-pressure hose and hose
whip so that no coating material escapes.
Do not bend the high pressure hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
• Hold the spray gun over an empty bucket.
• Set selector switch (2) to "F".
• Unlock the spray gun and pull the trigger guard (Fig. 7, 1)
(the pump begins to transport paint).
• As soon as coating material comes out of the spray gun, re-
lease the trigger guard.
• Screw the nozzle holder with the selected nozzle onto
the spray gun, align it and tighten it (see also the instruc-
tions for spray guns / nozzle holders).
The machine is now full and ready.

0
1
2 3

2
1

1
COMMISSIONING
PRESSURE
EN
33