Silvercrest SKMH 1100 A1 Bedienungsanleitung Seite 89

assembly 20 constitutes the seal for the
bottom of the jug 6.
Warning! Remember that the
blades of the assembly 20 are
extremely sharp. Never touch them
with your bare hands to avoid
cutting yourself.
Here is how to remove the blade
assembly 20:
1. Lay the blender jug 6 on its side.
2. Press the unlock lever on the
underside of the blender jug 6
so that it is pointing at the open
padlock symbol.
3. Carefully remove
assembly 20.
Here is how
assembly 20:
4. Lay the blender jug 6 on its side.
5. Insert the blade assembly 20 from the
inside. Note that the two protrusions on
the base of the blade assembly 20 have
to be inserted into the two holes in the
base of the blender jug 6.
Caution! Make sure that the rubber
seal 19 of the blade assembly 20 is
correctly seated, otherwise the contents are
liable to leak out.
88
the
to insert the
6. To lock the blade assembly 20,
press the unlock lever on the
underside of the blender jug 6
so that it is pointing at the
closed padlock symbol.
Note: Cut large pieces into smaller ones
with an edge length of about 3 – 4 cm.
Pieces larger than this may get jammed in
the blades.
7.3 Positioning the blender jug
1. Position the blender jug 6 in its
receptacle 14.
2. Press the blender jug 6 down slightly
until it meshes with the drive gear.
Notes:
– If the gears do not line up and you are
unable to press the blender jug 6
down, you may need to wriggle it
slightly to get the gears of the jug 6 to
slide into the receptacle 14.
– If the blender jug 6 is not positioned
correctly, a safety mechanism will
prevent the appliance from operating.
7.4 Inserting and removing the mixer
attachment
blade
The mixer attachment 22 is placed on the
blade
blade assembly 20 :
— It must be possible to completely
position the mixer attachment 22
without encountering any resistance. If
this proves not to be the case, rotate the
mixer attachment 22 through 90° and
position it afresh;
— The fins of the mixer attachment 22 are
accommodated in the spaces between
the blades;
Caution!
• The mixer attachment 22 may be used
only at speeds 1 to 4.