Cleaning And Maintenance; Repair & Maintenance - Concept ZN8091 Bedienungsanleitung

Limescale sedimentation preventive function (ANTI-CALC)
This function is based on the filtration of materials from the water used. It softens the used water, which reduces the
sedimentation of limescale in the steam chamber.
Self-clean function
This function allows cleaning minor sediment from the steam chamber. Use it once
every two weeks.
1. Fill the tank with water (see Filling with Water).
2. Insert the plug into the mains outlet.
3. Set the temperature control to the maximum.
4. Wait until the heating indicator light stops shining.
5. Hold the unit horizontally over a sink or wide water vessel.
6. Turn and hold the steam volume regulator in position OFF. Push and hold the
Self-clean button with your other hand (Figs. 2 and 3). Water will pour out of the
steam holes in the ironing surface, which will rinse minor sediment from the
steam chamber.
Automatic SHUT OFF function – for the ZN8091 only
This safety feature allows automatic shutoff if the unit is left on a horizontal ironing
surface for 30 seconds without moving, or for 10 minutes in the vertical position
without moving.
In these cases the unit will shut off automatically, a short beep will be heard, and the
automatic shutoff indicator will start blinking. The unit will turn on automatically
when moved.
Note: This function is just a safety measure. For normal shutoff, set the temperature
controller to minimum, and unplug the unit from the power source.
STORAGE
Pour the remaining water out of the tank. Keep the cooled unit in a vertical and stable position in a safe and dry place,
out of the reach of children

CLEANING AND MAINTENANCE

Unplug the unit from the power source.
Remnants of fabric fibers may be stuck to the ironing surface. Remove them with a soft cloth soaked in water and
vinegar. Then wipe the surface using a dry cloth.
Do not use any abrasives or steel wool to clean the ironing surface. Keep the ironing surface smooth; prevent it from
coming into contact with hard metal objects. Make sure the ironing surface is not scratched or damaged.
Clean the body with a wet cloth. Do not use aggressive substances for cleaning, such as solvents or abrasives!
Do not pour vinegar or other limescale removers in the water tank. To clean the steam holes, use a wet cloth, and
remove lumps and dust from the internal parts of the holes.
Do not immerse the power cord, plug, or appliance into water or any other liquid.
REPAIR & MAINTENANCE
Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an expert
service centre.
24
All manuals and user guides at all-guides.com
EN
Fig. 2
Fig. 3
ZN8091, ZN8092