Spare Parts; Foam Rubber Sealing Set; Hard Rubber Welding Strip; Sealing Tape (Glass Fabric Foil) - Lava V.100 PREMIUM X Bedienungsanleitung Und Sicherheitshinweise

10. Spare parts

All wearing parts of the vacuum sealer can be easily and independently re-
placed in a few steps.
10.1 Foam rubber realing set
Foam rubber realing set seals the vacuum chamber and ensures rapid pressure
build-up. Depending on the intensity of use or age, it can become contaminat-
ed, worn out, or porous.
Cleaning: If the foam rubber gasket is contaminated, rinse it several times with
lukewarm soapy water, being careful not to damage it.
Replacement: The gasket set can be easily and quickly replaced. Please refer to
the included installation instructions for guidance.
1. Unplug the device.
2. Lift the device cover.
3. Remove the lid seal and replace it with a new seal.
4. Remove the lower seal and replace it with a new seal.
Note: The foam rubber seals are not identical. Install the thicker seal on top and
the thinner one on the bottom.

10.2 Hard rubber welding strip

The black special hard rubber presses on the sealing tape during the vacuum
sealing process, ensuring an always optimal weld seam. Depending on the in-
tensity of use or age, abrasion may occur or the surface may change.
Replacement: The hard rubber welding strip can be easily and quickly replaced.
1. Unplug the device.
2. Lift the device cover.
3 . Carefully remove the welding strip made of hard rubber that needs to be
replaced.
4. I nsert the new sealing tape made of hard rubber in the same position (flat
edge against the foam rubber).
42

10.3 Sealing tape (glass fabric foil)

The durable, antistatic sealing tape (PTFE glass fabric foil) is placed over the
welding wire to prevent the bag from sticking during welding. Depending on
usage intensity or age, it may develop abrasion, bubbles, or waves. If the seal-
ing tape develops waves, it can be smoothed out by using a lint-free cloth and
applying slight pressure from the center towards the left and right. If this is not
sufficient, for example, if grease has penetrated underneath or if the black coat-
ing is peeling off, the sealing tape should be replaced.
Replacement: The sealing tape can be easily replaced by yourself. Please refer
to the supplied installation instructions for this purpose.
Note: After replacing and using the sealing tape for the first time, smooth it out
from the center to the left and right. This will help the adhesive to adhere even
better.

10.4 Bag attachment strip

The bag attachment strip collects a certain amount of potentially leaking
liquid during the vacuum sealing process in its integrated tray, thus protect-
ing the device from incoming liquid in the first step. If needed, this tray can
be removed and cleaned or replaced. Please contact customer service for
assistance with this.

10.5 Liquid separator

The liquid separator additionally protects the vacuum sealer from liquids. It con-
sists of the collection container, the rubber seal an the lid. All cleaning instructions
are listed under section 6.3.
Replacement: The individual components can be easily replaced.
1. Unplug the device.
2. The liquid separator container can be easily pulled out. (With new devices,
this may be more difficult initially. Note that there are two rubber seals under-
neath that must be preserved during reinstallation).
3. To remove the lid, pull it off the lid plunger. When reinstalling, ensure that the
lid is rectangular and not square, and insert it accordingly.
EN
43