Calibration - Blanco drink.soda EVOL-S Pro Bedienungsanleitung

Calibration

The system is optimally pre-set at the factory. If the dispensed volumes of the 3 types of water do
not match the amounts specified on the mixer tap, you can use the quantity calibration process to
set the system to the way you want it. These can be accessed via the menu (see page 45). To do
this you need a measuring cup with a fill height of at least 500 ml (0.5 l). The scaling wheel on the
mixer tap must not be set to "0" when starting the calibration process.
The display shows
"W1 500" for the first
dispensing volume of
500 ml. Place the
measuring beaker under
the soda water outlet
and confirm by pressing
"OK".
The system will dispense
another 500 ml and stop
automatically. Then use
the arrow keys to set
the value indicated on
the measuring cup and
confirm this by pressing
"OK".
The system will dispense
500 ml and stop automat-
ically. Then use the arrow
keys to set the value that
you read on the measuring
cup and confirm this with
"OK".
Your system is now
optimally adjusted and
the quantities dispensed
now correspond to the
volumes set on the mixer
tap!
The display shows
"W2 500" for the second
dispensing volume of
500 ml. Empty the
measuring beaker and
place it below the soda
water outlet again and
confirm by pressing
"OK".
51