Cameo OPUS SP5 PLUS Bedienungsanleitung Seite 17

Network
Network Activate / deactivate
Input network input
Protocol Network protocol
Universe 1 - 256,
Address
Set IP address and subnet mask
Output network signal
DMX OUT
via DMX OUT
W-DMX SETTINGS (Wireless)
Starting from the main display, press ENTER to enter the main menu. Use the and controls to
select the control menu Control and press ENTER. Use UP and DOWN to select the menu item
"Wireless" and confirm by pressing ENTER. For information on the W-DMX settings, please refer
to the table below. Confirm all changes to the settings with ENTER.
Wireless
W-DMX
Operating
(currently in beta status)
Transmitting
(currently in beta status)
Link
Receive Reset
OFF
ON
ArtNET
sACN
Universe
000 - 255
IP Address
IP Subnet
Mask
OFF
ON
OFF Deactivate W-DMX
ON Activate W-DMX
Receiver W-DMX module configured as receiver
Transmitter W-DMX module configured as transmitter
G3 G3 transmission standard
G4s G4S transmission standard
Pair with W-DMX devices. W-DMX must be enabled
Link on all devices, and the pairing with a transmitter
must be reset (Receive Reset)
Unlink Unpair all devices
NO Do not reset transmitter pairing
YES Reset transmitter pairing
Network input deactivated
Network input activated
ArtNet Protocol
sACN protocol
000 to 255. Change value with
LEFT and RIGHT, confirm with
ENTER.
Select block with LEFT and RIGHT,
change value with UP and DOWN,
confirm with ENTER.
Select block with LEFT and RIGHT,
change value with UP and DOWN,
confirm with ENTER.
Do not output signal
Output signal
17