Operation - Cameo OPUS SP5 PLUS Bedienungsanleitung

OPERATION

NOTES
As soon as the fixture is correctly connected to the mains, "Software
Update Please Wait..." and the Cameo logo with information on the
fixture model are shown in the display one after the other during the
start-up process and the motor reset. After this process, the spotlight is
ready for operation and the previously selected mode will be activa-
ted. On the one hand, the headlamp is operated with the help of the
touch-sensitive control panels next to the display; on the other hand,
the pressure-sensitive display (glove-compatible) itself can be used to
reach all menu items and make settings intuitively as desired. Informa-
tion on which control element in the display and which control panel
next to the display have the same function can be found in the adjacent
table. The following describes the operation using the control panels
next to the display.
MAIN DISPLAY
The top line of the display shows whether and which control signal is present at the unit, the line
below shows the currently activated operating mode (DMX Standard / Extended, Static, Auto,
Slave) and the DMX start address or the corresponding operating mode (in the example DMX
start address 001) is clearly visible in the middle. As soon as the control signal is interrupted, the
characters in the display start flashing and "None" (no signal) is displayed behind "Signal" in the
upper line. The display can be rotated 180° by tapping the touch-sensitive control panel DOWN; if
the display is already rotated 180°, tap the control panel UP to return the display to the standard
image. The display can also be rotated 180° by pressing the "roof symbol" in the pressure-sensi-
tive display.
Display of the input signal
DMX mode or operating mode
DMX start address or operating mode
Information on the device
model Back to main display =
any position in the display or
Press ENTER
Display battery status
Rotate display by 180
Main menu
15