BTS DC5D M K3 Serie Handbuch Seite 109

DC5xD MK3 GENSET CONTROLLER USER MANUAL
When the controller parameter "Action if the low oil pressure sensor is disabled". set to "anxiety"When the
oil pressure sensor is detected to be disconnected, then the signal start delay and duration (normal signal delay)
have not returned to the normal value, the oil pressure sensor alarm is reported. "ALARM» will light up, the
generator will light up stops working, displays "OP sensor open» in the case of a current malfunction, the
screen.
temperature sensor disabled alarm
the controller parameter "Action when the temperature sensor is turned off.on "anxiety», When the
temperature sensor is detected to be disconnected, Then start the alarm delay and the duration (Normal signal
delay) has not returned to the normal value, the temperature sensor disconnected alarm is reported. The
indicators will light up «"ALARM".up, Generator stops work, displays "The temperature sensor is open»
regarding the current malfunction of the screen.
fuel level sensor disabled alarm
When for the controller parameter "Action if the fuel level sensor is disconnected» set to «alarms", when it is
detected that the fuel level sensor is disconnected, then the delay alarm is triggered and in the duration (Normal
alarm delay) it has not returned to normal, in the alarm it is reported that the fuel level sensor has been
disconnected. The lights will light up «ALARM ",Generator stops running, displays "FL sensor open" on the
current fault screen.
finished frequency alarm
When the controller detects that the generator frequency is higher than "Over frequency alarm", Then the beginning
alarm delay and during the duration (Emergency delay) the mother will return to normal state, the
overfrequency is reported. "ALARM» will light up, the generator will light up stops working, displays "Over
frequency» regarding the current malfunction of the screen.
Under frequency alarm
When the controller detects that the generator frequency is lower than "Under alarm frequency", Then
start the alarm delay and the duration (Normal alarm delay) have not returned to normal, in the alarm
with under frequency is reported. "ANXIETY" indicators will light up, the generator will stop working, the
display will show "Lower frequency". current error screen
done Voltage alarm
When the controller detects that the generator voltage is higher than "Over voltage alarm», Then start the
alarm delay and the duration (Normal Alarm Delay) does not return to normal, the overvoltage is reported. The
lights will light up «ALARM ", Generator stops running, displays "The end of tension" on the current fault
screen.
Under Voltage alarm
When the controller detects that the generator voltage is lower than "Low voltage alarm», Then start the
alarm delay, and the duration (Normal Alarm Delay) should not return to normal, an emergency voltage drop
is reported. The indicators will light up « "ALARM".up, Generator stops running, displays "Under Voltage" on
the current malfunction screen.
the current alarm is over
When the controller detects that the generator phase current is higher than "Phase current signal
overload», then start signal delay and duration (Normal signal delay) have not returned to normal, an
overcurrent is reported. "ANXIETY" indicators will light up, the generator stops working, " is displayedOver
current» there is a malfunction of the screen.
power out alarm
When the controller detects that the power of the generator is higher than "Over total Power alarm", Then
start the alarm delay and duration (Normal Alarm Delay). does not return to normal, an overcapacity is
reported. The indicators will light up «"ALARM". up, Generator stops running, displays "power is over" is
enabled in the current fault screen.
An imbalance in the current ratio is alarming
25