Operation; Menu Structure; Stand-Alone Mode - EuroLite LED Theatre COB 200 WW Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board and the EUROLITE IR-7 remote control or in DMX-controlled mode via any
commercial DMX controller.

Menu structure

Mode
DMX mode
Automatic mode
Sound control
Running speed in
automatic mode and
sound control
Microphone sensitivity
for sound control
White color setting
Dimmer
Fading
Strobe effect
Sound control silent
scene
Behavior at missing DMX-
signal
Slave mode
IR remote control
Firmware version

Stand-alone mode

Automatic mode
In automatic mode, 4 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until AUTO is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program (01–04). Confirm with the
ENTER button.
2 Press the MENU button so many times until SPEED is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from 01 (slow) to 09
(fast). Confirm with the ENTER button.
Display
04CH
DMX 02CH
01CH
AUTO 01-04
SOUND 01-03
SPEED 01-09
SENSITIV 01-09
COLOR Ww:000-255
DIMMING 01-99
FADING 00-99
FLASH 00-99
SILENT
Blackout
DMX
lost
SLAVE SLAVE MODE
INFRARED
V1.0
24/32
ADDR:001-512
Auto program
Sound program
Program running speed
slow > fast
Microphone sensitivity
low > high
Warm white 0-100%
Total brightness (AUTO, SOUND
and COLOR modes)
dark > bright
Fading program with increasing
speed
Strobe effect with increasing speed
ON LEDs off if there is no music signal
OFF LEDs remain on if there is no music signal
LEDs go off
Hold Spot holds the last received signal
Full All LEDs 100% on
Goes to pre-selected auto program
Auto
01-04
Enable slave mode
ON IR remote control on
OFF IR remote control off
V1.0 Current firmware version number
Function
00131451, Version 1.1