Manual Mode; Battery Status - hillvert HT-IRI-06 Bedienungsanleitung

2) Program settings interface will be displayed. When START starts
flashing, the watering start time can be set. Press UP or DOWN to select
the hour, then press OK to select the minutes in the same manner.
3) Press the OK button to go to watering duration (RUN) (max. 9h59min).
Press UP or DOWN to select the hour, then press OK to select the
minutes in the same manner.
4) The work cycle (CYCLE) can be set as needed, so that it repeats at set
intervals (every 1 to 15 days) or only on designated days of the week.
5) To select the day of the week on which watering is to take place, press
UP or DOWN. When the chosen day starts flashing, press OK to confirm
the selection.
6) To cancel a day, select it using the UP or DOWN buttons and press the
OK button again.
7) If you want to water at designated time interval, i.e. every few days,
press the UP button to skip the selection of days of the week and move
on to selecting the frequency of watering. Press OK to complete the
work cycle setting. The program setting is now complete.

Manual mode

1) Press the MAN button to set the duration of irrigation.
2) Press UP or DOWN to select the hour, then press OK to select the
minutes in the same manner.
3) When the desired watering duration is displayed on the screen, press
the OK button to begin. The device will stop watering once the set time
has elapsed.
4) If manually initiated watering is requested to end, press the MAN
button again.
5) Press MENU to return to the clock.

Battery status

The battery symbol will flash when the power level is low. The device will
immediately stop watering. Batteries will need replacing.