Troubleshooting Guide - EINHELL 34.004.11 Bedienungsanleitung

Anl EM 1650_SPK1:Anl EM 1650_SPK1
GB
15. Troubleshooting
Fault
The motor fails to start
The motor performance drops
Cutting is irregular
Important!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is
overloaded and switches on again automatically after a short cooling period.
26
19.10.2006 10:31 Uhr
Possible causes
a) The capacitor is defective
b) There is no electricity at the plug
c) The cable is defective
d) The combined switch/plug is
defective
e) The connectors have become
separated from the motor
or the capacitor
f) The mower is standing in high
grass
g) The mower housing is clogged
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
a) The blade is worn
b) Wrong cutting height
Seite 26
Remedies
a) The mower housing is
clogged Have repaired by
the Customer Service
Center
b) Check the cable and the
fuse
c) Check the cable
d) Have repaired by the
Customer Service Center
e) Have repaired by the
Customer Service Center
f) Start in low grass or on an
area that has already
been mowed; change the
cutting height if necessary
g) Clean the housing so that
the blade moves freely
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
a) Replace or resharpen the
blade
b) Correct the cutting height