Setting mode
Press the On/Off button; if ALL programme
indicator lights are off and the End indicator
light is flashing, the appliance is in setting
mode.
Always remember that when performing
the following operations:
– selecting a washing programme,
– setting the water softener level,
– deactivating/activating the audible
signals,
the appliance MUST be in setting mode.
Press the On/Off button; if a programme in-
dicator light is on with a fixed light, the last
performed or selected programme is still set.
In this case, to return to setting mode the
programme has to be cancelled.
To cancel a set programme or a
programme in progress
Press and hold, for about 3 seconds, the
programme selection/cancel button until the
End indicator light is flashing. The pro-
gramme has been cancelled and the appli-
ance is now in setting mode.
Audible signals
Audible signals have been introduced to help
indicate which operations the appliance is
performing:
– end of the washing programme,
– intervention of an alarm due to malfunction
of the appliance.
Factory setting: audible signals activated
First use
Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level
Set the water softener
The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
It is possible to deactivate the audible
signals.
Deactivation/activation of the audible
signals
1. Press the on/off button. The appliance
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light.
3. Press programme selection/cancel but-
ton again. The programme light A comes
on with a fixed light and programme light
B starts flashing. Wait until programme
light A goes off. The programme light B
goes on flashing and the end of pro-
gramme indicator light is on with a fixed
light. This indicates that you have activa-
ted the function for deactivating/activat-
ing the audible signals. The fixed light of
the end of programme indicator light
means that the audible signals are acti-
vated.
4. To deactivate the audible signals, press
the programme selection/cancel button
again. The end of programme indicator
light goes off indicating that the audible
signals are deactivated.
5. To memorize the operation, switch off the
appliance by pressing the on/off button.
• To activate again the audible signals sim-
ply follow the above operations until the
end of programme indicator light comes
on.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. follow the instructions given
in 'Use of detergent'.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
69