First Use; Setting The Water Softener - Pelgrim GVW461ONY/P02 Anleitung

FIRST USE

Before using the dishwasher for the first time:
• Set the water hardness.
• Add 1 litre of water to the salt reservoir and then add 1.5 kg of dishwasher salt.
• Add rinse agent.
• Add detergent.

Setting the water softener

1. Open the door.
2. Press the "on/off" button to switch on the appliance.
3. Press the Rapid program button for more than 5 seconds to start the water softener set
model within 60 seconds after the appliance was switched on (the water softener and Rinse
agent warning lights will be on periodically when it get in the set model ).
4. Press the Rapid program button to select the proper set according to your local
environment, the sets will change in the following sequence: H1->H2->H3->H4->H5->H6 /
see water softener table.
5. Press the "on/off" button to end the setup mode.
Water softener table
Water hardness
ºClarke
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
The manufactory setting: H4 (EN 50242)
Contact your local water authority for information on the water hardness of your water supply.
EN 6
ºdH mmol/l
0 - 5 0 - 0,94
6 - 11 1,0 - 2,0
12 - 17 2,1 - 3,0
18 - 22 3,1 - 4,0
23 - 34 4,1 - 6,0
35 - 55 6,1 - 9,8
selector Position
H1 (Rapid)
H2 (90 min.)
H3 (90 min. + Rapid)
H4 (ECO)
H5 (ECO + Rapid)
H6 (ECO + 90 min.)
Salt consumption
(grams/cycle)
0
9
12
20
30
60