Error Codes - ETNA VW149M/E01 Gebrauchsanleitung

ERRORS

Error codes

P1 P2
* *
* *
*
*
*
*
*
* *
*
EN 22
1/2 3h 6h interference type
* *
Insufficient water
supply
*
Pressure system
failure
* *
Flooding safety
enabled
* * *
The dishwasher is
not pumping out
* * *
Heating error
* *
Flooding sound
signal activated
* *
Interference in the
electronics
* *
Temperature in the
machine is too high
* *
Interference of
heating sensor
*
High voltage failure
* *
Low voltage failure
Should the appliance become overfilled or exhibit excessive
leaking, shut off the inlet tap and alert the service department.
solution
• Make sure that the water faucet is completely
open and that there is no crack in the supply
hose
• Check if the supply hose is clogged
• Restart the dishwasher
• Please contact the service department if the
problem persists
• Please contact the service department
• Close the water faucet and contact the service
department
• Check if the drainage hose is connected
• Check the bottom filter and filter group
• Restart the dishwasher and terminate the last
selected program
• Please contact the service department if the
problem persists
• Please contact the service department
• Turn off the dishwasher and close the water
faucet
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department
• Please contact the service department