Care And Maintenance - Kärcher WD 3 Car Bedienungsanleitung

Suction tubes 2 x 0.5 m
Illustration
 Put both suction tubes together and connect them
with the handle.
Crevice nozzle, 350 mm
 For cleaning areas that are difficult to access, e.g.
between car seats.
Floor nozzle
(with inserts)
Illustration
 When vacuuming dry dirt off the floor, clip an insert
 When vacuuming water off the floor, clip an insert with two brush strips into the floor nozzle.
with two rubber lips into the floor nozzle.
Car vacuuming tool
 For quick and easy vehicle cleaning - from the foot-
well to the trunk.
Suction brush with hard bristles, white
 For thoroughly cleaning upholstery and carpet sur-
faces in the car. In desiccated dirt can be easily re-
moved with the sturdy bristles.
Suction brush with soft bristles, black
 For gentle cleaning of sensitive surfaces such as
car dashboard or center console.
Operation
ATTENTION
Always work with an inserted cartridge filter during wet
as well as dry vacuum cleaning!
Before Startup
Illustration
 Mount loose parts delivered with appliance prior to
start-up.
Start up
Illustration
 Connect accessories.
Illustration
 Plug in the mains plug.
Illustration
 Turn on the machine.
Dry vacuum cleaning
ATTENTION
Check the filter for damage prior to installation and re-
place as necessary.
Work with a dry cartridge filter only!
Illustration  Recommendation: To vacuum fine dust, use the
filter bag.
Information filter bag
– The filling level of the filter bag depends on the dirt
that is sucked in.
– The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
– Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a pre-filter.
Order no. basic design: 2.863-139.0, premium design:
2.863-161.0.
Wet vacuum cleaning
ATTENTION
Do not use a filter bag!
 For vacuuming up moisture or wetness pay atten-
tion to the correct floor nozzle insert and connect
the corresponding accessories.
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
 Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
 Remove the appliance head and empty the reser-
voir.
Storing the appliance
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.

Care and maintenance

 Clean the appliance and accessory parts made of
 If required, rinse the container and accessories plastic with a commercial plastic cleaner.
with water properly and dry them before reuse.
Illustration
 Only clean the cartridge filter under running water;
do not wipe or brush. Let it dry completely prior to
installation.
EN
– 8
Blowing function
Finish operation
13