Philips arcitec rq 1075 22 Bedienungsanleitung Seite 24

English
26
- The shaving heads may be damaged or
worn. Replace the shaving unit (see chapter
'Replacement').
2 Why doesn't the shaver work when I press the
on/off button?
- The battery may be empty. Recharge the battery
(see chapter 'Charging').
- The travel lock may be activated. Press the on/off
button for 3 seconds to deactivate the travel lock.
- The shaving unit is soiled or damaged to such an
extent that the motor cannot run. In this case,
the shaving unit symbol, the tap symbol and the
exclamation mark flash. When this happens, you
have to clean the shaving unit or replace it.
- The temperature of the shaver may be too high.
In this case, the shaver does not work and the
exclamation mark on the display flashes. As soon
as the temperature of the shaver has dropped
sufficiently, you can switch on the shaver again.
 Why isn't the shaver entirely clean after I
cleaned it in the Jet Clean System?
- The cleaning fluid in the cleaning chamber may be
soiled. Empty and rinse the cleaning chamber.
- The cleaning fluid level may be too low. If the
fluid volume in the cleaning chamber drops below
the minimum level during the cleaning program,
the program aborts.The cleaning light and the
'cleaning chamber empty' symbol flash at intervals
and the holder returns to its starting position.
Refill the cleaning chamber with cleaning fluid up
to the MAX indication (see chapter 'Cleaning and
maintenance').
- You may have used another cleaning fluid than
the original Philips cleaning fluid. Only use HQ200
cleaning fluid.