Transport And Storage; Product Selection, Project Engineering And Modification - Stahl 8150/1-Serie Betriebsanleitung

Transport and Storage

EN
4 Transport and Storage
EN
DANGER! Explosion due to damaged seal in devices with enclosure hinges!
EN
Non-compliance may result in serious or even fatal injury.
EN
 Devices with enclosure hinges must be transported only with a transport lock.
EN
 Transport and store the device carefully and in accordance with the safety notes
EN
(see "Safety" section).
EN
EN
5

Product Selection, Project Engineering and Modification

EN
DANGER! Explosion if the entire device is completely painted after manufacture!
EN
Non-compliance may result in serious or even fatal injuries.
EN
 Do not paint the device.
 Have all repairs performed by the manufacturer.
EN
EN
DANGER! Explosion due to defective sealing of the device!
Non-compliance may result in serious or even fatal injuries.
EN
 Do not create any additional drilled holes to apply labels or plates (on the outside).
EN
 Equip the enclosure only with suitable equipment (e.g. cable entries,
EN
EN
EN
 Observe the operating instructions from the manufacturers of the components and
EN
 Seal any unused cable entries with the stopping plugs approved for the type of
EN
EN
 Seal all open drilled holes by means of suitable equipment.
EN
EN When complying with the installation conditions and specifications on the rating plate:
 Check whether enough cable entries are provided. Create additional drilled holes if
EN
necessary, see Section 5.1.
EN
 Equip terminals and, if necessary, mount built-in components; see Section 5.3.
The primary methods considered for modification are remachining or retrofitting equipment
to the control and distribution boxes. The following options are available for this:
• Additional drilled holes on the flange plate, either by R. STAHL (Section 5.1.1)
or by the customer (Section 5.1.2.1)
• Additional drilled holes in the enclosure either by R. STAHL (Section 5.1.1)
or by the customer (Section 5.1.2.2)
• External add-on components either by R. STAHL or by the customer (Section 5.2)
• Internal built-in components either by R. STAHL or by the customer (Section 5.3)
8
Terminal Boxes
Series 8150/1, Series 8150/2
stopping plugs, or breathers) that is verifiably approved for use in hazardous areas
and meets the requirements of the IP protection rating.
Examples: EC Type Examination Certificate or IECEx Certificate of Conformity.
seals that are to be installed.
protection.
202161 / 815060300020
2020-05-08·BA00·III·en·07