Replacing The Rechargeable Battery - LIVARNO LUX 286717 Montage-, Bedienungs- Und Sicherheitshinweise

3. Ensure that the product is not illuminated by street lighting at
night. This can influence the effect.
Fix the mounting plate
(ø 6 mm) and the provided screws
the marking of the mounting plate ( UP) is showing vertically
upward (Fig. A).
Note: The enclosed mounting material is suitable for ordinary
masonry construction. Other wall substrates may require other
fastening materials. Seek specialist advice when in doubt.
Set the ON / OFF switch
operation of the product (Fig. G).
Note: In the "OFF" position both the light and the charging
function are disabled.
Attach the product to the mounting plate in such a way that
the hangers
on the back of the product. Slide the product downwards until
the hangers click into place in the receivers (Fig. B).
After mounting, check that the main unit is fitted securely.

Replacing the rechargeable battery

Note: Regularly clean the sensor and solar cell to ensure proper
functionality (refer to "Cleaning and care").
Replace the rechargeable battery as follows:
Slide the product upwards until the hangers
the receivers
Remove the product from the wall.
Set the ON / OFF switch
Loosen the fixing screws of the battery cover
these (Fig. D).
Remove the rechargeable battery
ment and replace it with a new rechargeable battery (Fig. E).
9
Use only rechargeable batteries of the recommended type
(see "Technical data"). Please note the polarity when inserting
the battery. This is indicated in the battery compartment.
Close the battery compartment by fixing the battery cover with
the fixing screws. Ensure that the arrow on the marking of the
battery compartment
Note: Ensure that you tighten the screws, otherwise, water could
get into the battery compartment and damage the rechargeable
battery or the product.
Return the ON / OFF switch to the position "ON" before you
return the product to the hooks of the mounting plate.
using the provided wall plugs
2
to the position "ON" to start the
11
of the mounting plate grip in the receivers
4
(Fig. B).
5
to position "OFF" (Fig. G).
11
( UP) points vertically upward (Fig. F).
8
. Ensure that the arrow on
3
release from
4
and remove
8
from the battery compart-
10
1
5
GB 11