Cleaning And Servicing; Troubleshooting; Storage - Bosch MultiTalent 3Plus MCM3P Serie Gebrauchsanleitung

en

Cleaning and servicing

Note: The longer the appliance remains
switched on, the finer the ingredients are cut.
Recommendations on using the accessories
can be found in the section "Recipes/
Ingredients/Processing".
After using the appliance
■ Set the rotary switch to P.
■ Remove mains plug.
■ Rotate universal cutter anti-clockwise and
remove.
■ Turn universal cutter over (blade insert
face up).
■ Loosen blade insert clockwise (l) and
remove from the universal cutter jug.
■ Empty jug.
■ Clean all parts, see "Cleaning and
servicing".
Cleaning and servicing
The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
An overview of cleaning the individual parts
can be found in Fig. G.
W Risk of electric shock
Never immerse the base unit in water or
place under running water.
Warning!
Surfaces may be damaged. Do not use
abrasive cleaning agents.
Note: If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.
Cleaning the base unit
■ Remove mains plug.
■ Wipe the base unit with a damp cloth.
If required, use a little detergent.
■ Then dry the base unit.
Cleaning the bowl and
accessories
W Risk of injury from sharp blades!
Do not touch blades of the universal blade
with bare hands. When not in use, always
store the universal blade in the blade guard.
Clean them with a brush. Do not grip the
sharp blades or edges of the cutting discs.
26
Grip the discs by the plastic part in the centre
only!
All parts are dishwasher-proof. Do not
wedge plastic parts in the dishwasher as
they could warp.
Cleaning the blender /
universal cutter
W Risk of injury from sharp blades!
Do not touch blades of the blade insert with
bare hands. Clean them with a brush.
The blender jug (without blade insert), lid
and funnel are dishwasher-proof.
Do not clean the blade insert in the dish-
washer, but under running water (do not
soak in water). Remove seal for cleaning.

Troubleshooting

W Risk of injury!
Before rectifying a fault, pull out the
mains plug.
Fault:
Appliance does not start or appliance
switches off during operation.
Possible cause:
Bowl or lid or the accessory has not been
attached correctly or has become detached.
Remedial action:
■ Set the rotary switch to P.
■ Correctly attach bowl/lid or accessory and
screw on all the way.
■ Switch the appliance on again.
Important information
If the fault cannot be eliminated, please
contact customer service (see customer
service addresses at the end of this booklet).

Storage

Fig. H
The tools can be stored in the bowl to save
space.