Husqvarna 215iHD55 Bedienungsanweisung Seite 10

• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved mains sockets that are not damaged.
Make sure that the cord of the battery charger is not
damaged. If extension cables are used, make sure
that the extension cables are not damaged.
• Do not charge non-rechargeable batteries in the
battery chargers.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
Introduction
This section describes how to assemble and adjust the
product.
WARNING:
product, read the safety chapter and the
assembly instructions.
To connect the battery to the product
WARNING:
original batteries in the product.
1. Fully charge the battery.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 27)
CAUTION:
move easily into the battery holder, the
Introduction
WARNING:
safety chapter before you use the product.
10
Read the warning
Assembly
Before you assemble the
Only use Husqvarna
If the battery does not
Operation
Read and understand the
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
battery is not installed correctly. This can
cause damage to the product.
To install the battery charger (40-C80)
on the wall
CAUTION:
Do not use an electric
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
1. Install the battery charger on the wall with the 2
screws (B). Use wall plugs (A) if it is necessary. (Fig.
28)
2. Install the 2 screw hole plugs (C).
3. Connect the power cord to the battery charger and a
mains socket.
Battery
WARNING:
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
Keep the battery and the battery charger in the correct
ambient temperatures.
Read and understand the
1980 - 001 - 23.12.2022