Residual Risk - BATTIPAV PRIME SUPREME Bedienungsanleitung

Battipav srl
CUTTING PROGRESS SYSTEM
26 The "CUTTING PROGRESS SYSTEM" can be used to adjust – in a very precise manner and by means of the
hand wheel located on the machine front upright – the cutting head forward or backward movement.
GIVEN THE ACCESSORY HIGH SENSITIVITY, PROCEED WITH CAUTION SO AS NOT TO ACCIDENTALLY
LOCK THE CUTTING TOOL.

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the
safety and health of operators.
In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system. CONNECT THE MACHINE TO A SYSTEM WITH
DIFFERENTIAL PROTECTION AND EFFECTIVE EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 15) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE
SUPPLY MAINS.
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with two registers for the motor head vertical play adjustment.
For correct adjustment, proceed as follows:
• with a 3 mm Allen wrench, screw both front adjustment dowels (A), until the play is eliminated;
27
• repeat the operation for both back adjustment dowels (B);
28
TIGHTEN THE FOUR REGISTERS EQUALLY IN ORDER TO OBTAIN SUITABLE SMOOTHNESS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
It is extremely easy to clean the PRIME / SUPREME machine by loosening the locking nuts and dismantling
29
the working table. Through the tap located on the bottom of the recovery tank, remove any working residual
from the machine.
AFTER THE TANK CLEANING OPERATIONS, PLACE THE WORKING TABLE BACK IN POSITION, OBSERVING
30
THE DISTANCE FROM THE LEG SUPPORT.
Clean the sprayer regularly as indicated.
31 32
GB
51