Troubleshooting; Specifications - Stihl RM 448.1 VC Gebrauchsanleitung

18 Troubleshooting

18 Troubleshooting
18.1 Remedying Lawn Mower Faults
Fault Cause
Engine cannot Control bar for mowing is not
be started. pressed.
Fuel tank is empty.
Fuel line is blocked.
Inferior, dirty or old fuel in the
tank.
Air filter is dirty.
Spark plug socket is detached
from spark plug or ignition lead
is not properly fastened to
socket.
Spark plug is dirty, damaged or
electrode gap is incorrect.
Resistance at the blade is too
great.
Engine diffi‐ Lawn mower housing is
cult to start or blocked.
engine power
deteriorating.
Cutting height is set too low or
rate of feed is too high.
Water in fuel tank and carburet‐
tor or carburettor is blocked.
Fuel tank is contaminated.
Air filter is dirty.
Spark plug is dirty.
Engine over‐
Engine oil level is too low.
heating.
Cooling ribs are dirty.
Lawn mower Blade is damaged.
vibrates
excessively.
Blade is not correctly attached.
Grass is not Blade is blunt or worn.
being cut
cleanly.

19 Specifications

19.1 STIHL RM 448.1 VC Lawn
Mower
– Engine type: STIHL EVC 300.0
– Displacement: 166 cm³
– Power: 2.6 kW (3.5 hp) at 2800 rpm
– Speed: 2800 rpm
– Maximum fuel tank capacity: 900 cm³ (0.9 l)
– Weight: 29 kg
– Maximum grass catcher box capacity: 55 l
– Cutting width: 46 cm
0478-111-9904-A
Remedy
► Start engine as described in this instruction
manual.
► Refuel lawn mower.
► Consult a STIHL specialist dealer.
► Use fresh, good-quality unleaded petrol.
► Consult a STIHL specialist dealer.
► Connect spark plug socket.
► Check connection between ignition lead and plug.
► Clean or replace spark plug.
► Adjust electrode gap.
► Set a higher cutting height.
► Start engine in lower grass.
Clean lawn mower.
Adapt cutting height or mow more slowly.
Empty fuel tank, clean fuel line and carburettor.
Consult a STIHL specialist dealer.
Consult a STIHL specialist dealer.
Clean or replace spark plug.
Add or change engine oil as described in the engine
instruction manual.
Clean lawn mower.
Replace blade.
Attach blade.
Sharpen or replace blade.
19.2 Blade
– Minimum thickness a: 2.0 mm
– Minimum width b: 39 mm
– Sharpening angle c: 30°
19.3 Sound Values and Vibration
Values
The K value for the sound pressure level is
2 dB(A). The K value for the sound power level is
1.1 dB(A). The K value for the vibration value is
2.20 m/s².
English
35