Safety Instructions For Maintenance; Operation - Husqvarna PG 540 Bedienungsanweisung

• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
• Do not make modifications to safety devices.
Emergency stop button
The emergency stop button is used to quickly stop the
motor. The emergency stop button breaks the mains
power supply.
CAUTION:
stop button as the stop button for the
product.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To remove the product from the
package
WARNING:
pallet carefully and safely. The product is
heavy and can cause serious injury if it falls.
8
Read the warning
Do not use the emergency

Operation

Before you operate the
Move the product from the
To do a check of the emergency stop button
1. Turn the emergency stop button (A) on the control
panel clockwise to make sure that the emergency
stop button is disengaged.
2. Turn the ON/OFF switch (B) on the control panel to 1
to start the motor. The LED adjacent to the ON/OFF
switch comes on.
3. Push the emergency stop button.
4. Make sure that LED adjacent to the ON/OFF switch
goes off.
5. Turn the emergency stop button clockwise to
disengage.

Safety instructions for maintenance

• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools. Turn the ON/OFF switch to 0 and push the
emergency stop button.
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Do the maintenance to make sure that the product
operates correctly. Refer to
on page 16 .
• Make sure that all items that is shown in the product
overview, are included. Refer to
right side on page 2 . Speak to your Husqvarna
dealer if an item is missing or damaged before you
move the product from the pallet.
• Remove all package straps and wheel chocks.
• Make sure that the area is clear and that you have
sufficient space to move the product.
• Make sure that there is no risk that you or the
product can fall.
• Use lifting equipment or ramps to move the product
from the pallet. The product is heavy. Move the
product safely. Refer to
20 .
A
B
Maintenance schedule
Product overview,
To lift the product on page
1211 - 004 - 09.12.2022