Husqvarna PG 540 Bedienungsanweisung Seite 13

3. Hang the power cord on the suspension device at
the door to electrical box to prevent tension in the
power cord.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to a 3-phase
power source.
Operation speed
If the product is operated on a new surface type, set
the speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
Direction of rotation of the grinding
discs
Seen from below the product, the direction of rotation is
as follows:
• "CW": clockwise
• "CCW": counterclockwise
During operation the product can pull to the side. The
direction of the pull is related to the direction of rotation.
The product pulls to the right when the direction of
rotation is set to "CCW". The product pulls to the left
when the direction of rotation is set to "CW".
The side pull can help you operate the product for
example near a wall. Set the direction of rotation to pull
in the direction of the wall.
CAUTION:
Make sure that the product only lightly
touches the wall. The product is heavy and
can cause damage.
1211 - 004 - 09.12.2022
When the product is
Steer the product carefully.
To change the speed and direction of rotation
of the motor
Change the direction of rotation regularly to increase
the life and the sharpness of the diamond tools. The
diamond tool segments are used equally and the contact
surface continues to be as large as possible.
• To set the speed and direction of rotation of the
grinding disc, turn the knob.
To operate the product
• Operate the product manually with the control panel
on the handle. Refer to
on page 3 .
• During operation, look for color changes in the
indicator for the inverter to the grinding motor (A).
A
• Green light: the product operates correctly.
• Orange light: there is an overload in the grinding
head. Decrease the power output in 10 seconds
or less to prevent that a fault occurs.
• Red light: fault in the inverter and the grinding
head stops. It is necessary to reset the product.
To reset the product on page 14 .
Refer to
To start the product
CAUTION:
time while the grinding head is on. If you
do not move the product, the surface can
become rough.
1. Push down the handlebar slightly to lift the grinding
head from the surface. This releases the surface
friction of the diamond tools. Do not lift the grinding
head fully from the surface during operation.
Product overview, left side
Move the product all the
13