Safety Instructions For Maintenance; Operation - Husqvarna BMG 555 Bedienungsanweisung

• Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
Emergency stop button
The emergency stop button is used to quickly stop the
motor.
To do a check of the emergency stop button
1. Turn the emergency stop button (A) clockwise
to make sure that the emergency stop button is
disengaged.
2. Start the product. Refer to
control panel without speed adjustment on page 42 .
3. Push the emergency stop button.
4. Make sure that the motor stops.
5. Turn the emergency stop button clockwise to
disengage.
Operator Presence Control (OPC)
When the OPC is engaged, the motor stops. Refer to
do a check of the Operator Presence Control (OPC) on
page 39 .
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 37 .
4. Make sure that only approved persons are in the
work area.
1806 - 002 - 14.04.2022
A
To start the product,
Before you operate the
To do a check of the Operator Presence Control (OPC)
1. Start the product. Refer to
control panel without speed adjustment on page 42 .
2. Pull out the OPC key. If the motor does not stop in
3 seconds, speak to an approved Husqvarna service
agent.

Safety instructions for maintenance

• Use personal protective equipment. Refer to
Personal protective equipment on page 37 .
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools.
• Do the maintenance with the motor stopped and
the power plug disconnected. Always let the motor
become cool before you do maintenance of the
product.
• Do the maintenance of the product on stable level
ground.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Do the maintenance to make sure that the product
operates correctly. Refer to
on page 45
• Set out clear signs to give a warning to bystanders
that maintenance work is in progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
To

Operation

5. Do daily maintenance. Refer to
schedule on page 45 .
6. Make sure that the product is assembled correctly
and is not damaged.
7. Put the product on the work area. Make sure that the
surface is level. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
8. Make sure that there are diamond tools on the
grinding head and that they are tightly attached.
9. For dry grinding connect a dust extractor to the
product. Refer to
page 41 .
10. For wet grinding, connect the water supply. Refer to
To connect the water supply on page 41 .
11. Connect the product to a power source. Refer to
connect the product to a power source on page 41 .
To start the product,
Maintenance schedule
Maintenance
Transportation on page 55 .
To connect a dust extractor on
To
39