Specified Conditions Of Use; Ec Declaration Of Conformity; Mains Connection - AEG TS 250 K Originalbetriebsanleitung

Do not use any flanges other than those supplied or indicated in the
instruction manual to secure the saw blade.
Refrain from removing any cut-offs or other parts of the workpiece
from the cutting area whilst the machine is running and the saw
head is not in the rest position.
Ensure that the machine is always stable and secure (e.g. fixed to
a bench)
Long workpieces must be adequately supported.
Do not use cracked or distorted saw blades.
Stock having a round or irregular cross section (such as firewood)
must not be cut, as it can not be securely held during cutting. When
sawing thin stock layed on edge, a suitable auxilary fence must be
used for firm support.
Transport and store the tools in a suitable receptacle;
Only use tools that meet standard EN 847-1.
To minimise noise, the tool must be sharpened and all noise
reducing elements (covers etc.) must be properly adjusted.
Cutting rebates or grooves is only permitted with a suitable
protective device fi tted, e.g. a protective tunnel over the saw table.
Do not use circular saws for cutting slots (grooves in workpiece).
Do not use the top protective cover as a handle for transportation!
Before transporting the machine, make sure that the top protective
guard covers the top section of the saw blade.
In spite of compliance with all relevant design regulations, dangers
may still present themselves when the machine is operated, e.g.:
- workpiece parts being thrown off,
- parts of damaged tools being thrown off,
- noise emissions,
- wood dust emissions.

SPECIFIED CONDITIONS OF USE

Use this circular saw to cut only wood and wood like products.
Do not use this product in any other way as stated for normal use.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents. EN 61029, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3, in accordance with the regulations
2006/42/EC, 2004/108/EC
Winnenden, 2010-02-22

MAINS CONNECTION

Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also possible
to connect to sockets without an earthing contact as the design
conforms to safety class II.
Rainer Kumpf
Manager Product Development
Authorized to compile the technical file.
MAINTENANCE
Clean out sawdust from the interior of the saw to prevent a potential
fire hazard. Do not use saw blades which are damaged or deformed.
Use only AEG accessories and AEG spare parts. Should components
need to be replaced which have not been described, please contact
one of our AEG service agents (see our list of guarantee/service
addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden,
Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Wear ear protectors!
Always wear goggles when using the machine.
Always keep hands away from the path of the saw
blade.
Never expose tool to rain.
Danger
Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation
in accordance with national law, electric tools that
have reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.
Accessory - Not included in standard equipment,
available as an accessory.
GB
English
21