Remote Control Socket; Dmx-Controlled Operation; Addressing - EuroLite LED BR-60 Bedienungsanleitung

Rotations Reverse
With this function you can reverse the rotation movement.
Display shutoff
With this function you can shut off the LED display.
– permanent on
– shut off the display after 5 seconds

Remote Control socket

Via the optional available Easy-4 remote control you can run the auto, sound and standby mode. For this
connect your Easy-4 remote control to the remote control socket.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED BR-60 beam effect will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED BR-60 beam
effect correctly and independently from any other fixture on the DMX data link.
If two, three or more LED BR-60 beam effects are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows „A001" and set the desired address via
the Up/Down-buttons.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show "A.001" with the actually set address. If there is no data received at the
DMX-input, the display will show "A001".
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the LED BR-
60 beam effect.
- the controller is switched off or defective.
- the cable or connector is defective or the signal wires are swap in the input connector.
24/28 00106604, Version 1.0