Remote Control Ir-7; Dmx Operation - EuroLite LED PIX-12 QCL Leiste Bedienungsanleitung

Remote control IR-7

The device must be activated for remote control. For this, set menu item InFr to on. When actuating a
button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise, operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 52 control channels.
However, it can also be switched to a mode with 2, 3, 4, 4-1, or 15 channels if different functions are
required. To be able to operate the device with a DMX controller, the DMX starting address must be set. The
starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
1 Press the MENU button so many times until Addr is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 2 CH (2 DMX channels), 3 CH (3 DMX channels), 4 CH (4 DMX channels), 4-1 C
(4 DMX channels), 15 CH (15 DMX channels) or 52 CH (52 DMX channels). Use the buttons UP and
DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
3 Now the display indicates the menu item for the DMX start address d001. Use the buttons UP and
DOWN to set the address. Confirm with the ENTER button.
4 A dot will flash when DMX signals are being received. If the control signals are missing, the display and
the dot flash alternately.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Button Function
BLACKOUT LEDs off
AUTO Automatic mode; program selection with (+)/(‒)
SOUND
Sound control; program selection with (+)/(‒)
Strobe effect for automatic mode + sound control; flash
STROBE rate setting with (+)/(‒).Press the strobe button again to
exit the program.
Running speed in
SPEED
setting with (+)/(‒)
SENSITIVITY Microphone sensitivity; setting with (+)/(‒)
DMX
DMX mode
MANUAL Color mode; select colors with R/G/B/W and (+)/(‒)
Color fade mode, press the fade button again to exit the
FADE
program.
1-9 Total brightness; 1 = dark, 9 = bright
27/34
automatic mode + sound control,
00122808, Version 1.0