Installation Of Propeller And Fin - Torqeedo Cruise 12.0 R TorqLink Originalbetriebsanleitung

Start-up
3. Tighten the two transom clamp bolts (1).
4. Additionally, attach the drive using four M12 mounting screws, by screwing the
drive to the boat's transom through the drilled holes for the clamping jaws (2) of
the transom bracket.
Fig. 33: Installation position
When attaching the motor to the boat, ensure that the propeller is mounted at least
10 to 30 mm below the boat hull.
Make sure that the transom bracket is entirely above the waterline.
10-30 mm
(0.4-1.2 in.)
5.2

Installation of propeller and fin

Installation of fin
WARNIN G!
Danger of injury from propeller!
Moderate or severe physical injuries may result.
Keep away from the propeller.
When working on the propeller, always switch the system off at the main
switch.
Pull out the Emergency Stop magnetic chip.
Comply with the safety provisions.
Beware of people in the water.
EN DE
page 75 / 116